12V DC Relay Controller Soil Moisture Humidity Sensor Module Automatically Watering for Arduino

750.00

Description

Using high-quality soil sensors do detect soil moisture, the surface of nickel plated , has widened the induction area can improve conductivity, prevent contact with the soil rust problems and prolong life;
nWhen two products can control a wide range of soil moisture, the corresponding threshold by adjusting potentiometer control, humidity is below the set value, start relay, while higher than the set value, the relay is disconnected;
nProducts with the delay function, delay of 3-5 seconds, when the humidity is detected in the critical state, the relay will not blink, flicker occurs;
nHigh-quality products using Songle relay can withstand 1500W load, to meet the requirements of most people;
nProducts with power indicator
nSpecifications:
nSupply voltage: 12VDC
nInput current: More than 100ma
nLoad: 250V 10A AC or 30V 10A DC (below current in this range can be used)
nuse:
nSensor for detecting moisture in the soil;
nModule is the blue potentiometer to adjust the threshold for soil moisture , clockwise adjustment, control humidity will be bigger, smaller counter-clockwise;
nDue to the module with delay function in the regulation of humidity values, adjusted once every 5-8 seconds to wait around to see if changes in the relay, the green LED lights also have a corresponding change until transferred to meet the requirement.
nProduct wiring information , refer to the picture below.

Reviews

There are no reviews yet.

Be the first to review “12V DC Relay Controller Soil Moisture Humidity Sensor Module Automatically Watering for Arduino”

Your email address will not be published. Required fields are marked *

X