A4988/DRV8825 3D Printer Stepper Motor Driver Control Extension Shield Board

400.00

Description

1. If jumper is hit the position of ON DP,
nthat means 16 segment (4988) or 32 segment (8825)Jm connected motor
n
n2. Jv connect 5v and 12v-24v power supply
n
n3. Jc E, S, D, G, respectively corresponding to the connection
nof the Enable/Step/Dir/Gnd drive signal output
n
nNotice:
nPay attention to when installation direction,
notherwise it may burn drive even the mainboard

Reviews

There are no reviews yet.

Be the first to review “A4988/DRV8825 3D Printer Stepper Motor Driver Control Extension Shield Board”

Your email address will not be published. Required fields are marked *

X