nOperating Voltage 5V
nInput Voltage (recommended) 7-12V
nInput Voltage (limits) 6-20V
nDigital I/O Pins 54 (of which 15 provide PWM output)
nAnalog Input Pins 16
nDC Current per I/O Pin 40 mA
nDC Current for 3.3V Pin 50 mA
nFlash Memory 256 KB of which 8 KB used by bootloader
nSRAM 8 KB
nEEPROM 4 KB
nClock Speed 16 MHz
nThe Arduino Mega can be powered via the USB connection or with an external power supply. The power source is selected automatically.
nExternal (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board’s power jack. Leads from a battery can be inserted in the Gnd and Vin pin headers of the POWER connector.
nThe board can operate on an external supply of 6 to 20 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. If using more than 12V, the voltage regulator may overheat and damage the board. The recommended range is 7 to 12 volts.
nThe power pins are as follows:
nVIN. The input voltage to the Arduino board when it’s using an external power source (as opposed to 5 volts from the USB connection or other regulated power source). You can supply voltage through this pin, or, if supplying voltage via the power jack, access it through this pin.
n5V. This pin outputs a regulated 5V from the regulator on the board. The board can be supplied with power either from the DC power jack (7 – 12V), the USB connector (5V), or the VIN pin of the board (7-12V). Supplying voltage via the 5V or 3.3V pins bypasses the regulator, and can damage your board. We don’t advise it.
n3V3. A 3.3 volt supply generated by the on-board regulator. Maximum current draw is 50 mA.
nGND. Ground pins.
nIOREF. This pin on the Arduino board provides the voltage reference with which the microcontroller operates. A properly configured shield can read the IOREF pin voltage and select the appropriate power source or enable voltage translators on the outputs for working with the 5V or 3.3V.
nThe ATmega2560 has 256 KB of flash memory for storing code (of which 8 KB is used for the bootloader), 8 KB of SRAM and 4 KB of EEPROM (which can be read and written with the EEPROM library).