Multifunction CJMCU FT232H USB to JTAG UART/ FIFO SPI/ I2C module High-speed

1,750.00

Description

Specification
n
nModel; CJMU232H
nSingle chip USB to UART (RS232, RS422 or RS485)
nUSB to FIFO
nUSB to FT1248
nUSB to JTAG
nUSB to SPI
nUSB to I2C
nUSB to Bit-Bang
nUSB to Fast Serial Interface
nUSB to CPU target interface (as memory)
nCJMCU-FT232H is a single channel USB 2.0 Hi-Speed (480Mb/s) to UART/FIFO IC.
nSingle channel USB to serial/parallel ports with a variety of configurations.
nEntire USB protocol handled on the chip. No USB specific firmware programming required.
nUSB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible.
nMulti-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design.
nUART transfer data rate up to 12Mbaud. (RS232 Data Rate limited by external level shifter).
nUSB to asynchronous 245 FIFO mode for transfer data rate up to 8 Mbyte/Sec.
nUSB to synchronous 245 parallel FIFO mode for transfers up to 40 Mbytes/Sec
nSupports a proprietary half duplex FT1248 interface with a configurable width, a bi-directional data bus (1, 2, 4 or 8 bits wide).
nCPU-style FIFO interface mode simplifies CPU interface design.
nFast serial interface option.
nFTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
nAdjustable receive buffer timeout.
nLike our page
n


nElectronics Panga
n

Reviews

There are no reviews yet.

Be the first to review “Multifunction CJMCU FT232H USB to JTAG UART/ FIFO SPI/ I2C module High-speed”

Your email address will not be published. Required fields are marked *

X